Viewing 12 posts - 1 through 12 (of 12 total)
That does the trick. Thanks!
March 13, 2019 at 10:50 am
February 14, 2019 at 2:06 pm
February 14, 2019 at 2:05 pm
December 14, 2017 at 2:24 pm
October 20, 2017 at 10:48 am
Thanks for your replies, all. If I pull the data from a table rather than a SQL command it works fine so I'm just going to do that.
August 2, 2017 at 8:15 am
I do have two expression columns but they are aliased. Everything shows up properly in the preview.
August 1, 2017 at 2:55 pm
June 29, 2017 at 3:10 pm
May 16, 2017 at 11:48 am
Thanks for the replies folks. I'll just pull the reports in question and put them in my own solution.
April 19, 2017 at 9:33 am
March 24, 2017 at 12:43 pm
Correct - if the SETUP_TIME is equal to zero then I want to return zero. If the SETUP_TIME is other than zero I want to return the result of SETUP_TIME...
March 24, 2017 at 12:04 pm
Viewing 12 posts - 1 through 12 (of 12 total)