February 22, 2006 at 11:20 am
Has anyone had any issues applying the SP4 hotfix for AWE enabled servers?
TIA,
dab
February 22, 2006 at 1:21 pm
well i have upgraded to sp4 and applied to hot fix to build 2040 on some of the servers in our env...had no isuues..
-Krishnan
February 23, 2006 at 6:32 am
We have the awe fix on several instances and have had no problems.
February 23, 2006 at 6:43 am
100+ servers - no problems.
MG
"There are two ways of constructing a software design. One way is to make it so simple that there are obviously no deficiencies. And the other way is to make it so complicated that there are no obvious deficiencies."
Tony Hoare
"If you think it's expensive to hire a professional to do the job, wait until you hire an amateur." Red Adair.
February 23, 2006 at 9:15 am
We've seen it not install on all nodes in a clustered environment. It doesn't give an error message...it says it was successful, but "select @@version" shows 8.00.2039 instead of 8.00.2040 when the cluster group is moved to the opposite node from where the AWE hotfix was installed.
February 24, 2006 at 9:03 am
Installed it a few weeks ago and have not had any issues.
February 24, 2006 at 5:49 pm
K....
I did read in another post on another site that the hotfix fails in a clustered environment if Task Scheduler is turned off.
dab
June 3, 2006 at 5:26 am
4 hours with Microsoft but still could not install AWE hotfix on cluster. It does not give error message but RAM is still half used. Did any one got any solution for this?
Jigar Patel
Viewing 8 posts - 1 through 7 (of 7 total)
You must be logged in to reply to this topic. Login to reply