Post reply

Installing SQL Server 2005 Enterprise x-64 bit on Windows 2003 SP1 cluster

  • April 30, 2006 at 8:35 pm

    #168756

    Hello!
     
        I am pretty new in clustering world. I managed to install\configure and test Active/Passive cluster on Windows 2003 x-64 bit SP1. When I try to run installation of SQL Server 2005 x-64 bit, I only have an option to install client tools. SQL Server/Reporting Service/Notification services etc. is not available at 'Feature selection' screen. 'System configuration check' checks both nodes and comes back with OK status. 
        I am not sure why I am unable to select services during installation. I am pretty much sure installation is correct (SQL Server 2005 x-64 bit).
    Any help is greatly appreciated.
     
    Igor

  • May 3, 2006 at 8:00 am

    This was removed by the editor as SPAM

  • May 16, 2006 at 5:57 am

    #638111

    I've run into a similar issue and from what I have found, IIS (5.0 or later) needs to be installed prior to installing RS. I haven't tried it yet as I just found it this morning after having my first installation fail.

    The requirements page on the MS site lists it as needed:

     

    http://www.microsoft.com/sql/prodinfo/sysreqs/default.mspx

    MG

    "There are two ways of constructing a software design. One way is to make it so simple that there are obviously no deficiencies. And the other way is to make it so complicated that there are no obvious deficiencies."
    Tony Hoare

    "If you think it's expensive to hire a professional to do the job, wait until you hire an amateur." Red Adair.

  • May 16, 2006 at 3:54 pm

    #638297

    It turned out I was missing one of the installation CDs.

    Igor

     

Viewing 4 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic. Login to reply